Procedure
1. Select an incomplete device description and then select the Complete device
information... command in the shortcut menu.
2. Complete the device description.
3. Click "OK".
Note
Saving the changes
● If the device description is located on a read-only medium, changes cannot be made.
In this case, copy the device description to a medium that is not write-protected and
start the process again.
● The changes will remain available in the Device Integration Manager until the dialog
box is closed. When you click the "OK" button, the changes are applied to the device
description.
4. Click "Integrate".
The integration of the device description is performed.
Additional information
You can find information on the device list entries in the section "Device list (Page 35)".
5.4.3 Creating your own device library using the project filter
Introduction
You use the following procedure to create your own device library using the project filter.
Project filter
Information on the project filter and its application is available in the section "Applying a project
filter (Page 51)".
Procedure
1. Read in the device descriptions of a standard library.
2. Apply a project filter.
3. Select the Catalog > Creating user-specific device DVD... menu command.
4. Enter the destination path in the "Create own device library... " dialog box.
5. Enter the device library name or the version identification of the device library.
Integrating devices into SIMATIC PDM
5.4 Working with the Device Integration Manager
Help for SIMATIC PDM (V8.2)
42 Operating Manual, 02/2014, A5E33203676-AA
To Next Page
Loading...
