Siemens SIMATIC S7 EIP-200S - Page 34

EIP-200S Ethernet/IP Adapter
2.6 Device profile: supported CIP objects
EIP-200S Ethernet/IP Adapter Distributed I/O System
34 System Manual, 06/2018, A5E44345053-AB
Attribute
ID
Access
rule
Description
Data type
Default value
Semantics of values
6 Set Host name STRING 0x00E (length =
14) plus hex
equivalent of
"br+MAC" (2+12
digits)
ASCII characters. Maxi-
mum length is 48 charac-
ters. Padded to an even
number of characters (pad
not included in length). A
length of 0 indicates no
host name is configured.
12 Set Ethernet/IP
QuickConnect
BOOL 0 0 = disabled
1 = enabled
13 Set Encapsulation
Inactivity
Timeout
UINT 0 = disabled
1-3600 = timeout in sec-
onds
Default = 120
Table for "Interface status", Attribute 1
Bit(s):
Called:
Definition
0 - 3 Interface Con-
figuration Status
Indicates the status of
the Interface Configura-
tion attribute.
0 = The Interface Configuration attribute has not
been configured
1 = The Interface Configuration attribute con-
tains valid configuration obtained from BOOTP,
DHCP, or non-volatile storage.
2 = The Interface Configuration attribute con-
tains valid configuration, obtained from hard-
ware settings (for example, pushwheel,
thumbwheel, etc.)
3 - 15 = Reserved for future use
4 Mcast Pending Indicates a pending configuration change in the TTL Value and/or
McastConfig attributes. This bit is set when either the TTL Value or
McastConfig attribute is set, and cleared the next time the device starts.
5 - 31
Reserved
Reserved for future use and set to zero.
Common services for TCP/IP Interface Object
Service
code
Service available
Service name
Description
Class
Instance
0x01
Yes
Yes
Get_Attribute_All
Supplies contents of all attributes
0x0E Yes Yes Get_Attribute_Single Supplies contents of the appropriate
attribute
0x10
No
Yes
Set_Attribute_Single
Modifies an attribute value