Siemens SINAMICS G120D Series - Page 55

Installation
4.2 Electrical Installation
Default setting 9: "Standard I/O with MOP"
DO 0: p0730, DO 1: p0731
DI 0: r0722.0, …, DI 3: r0722.3
Motorized potentiometer, setpoint after the ramp-function generator r1050
Speed setpoint (main setpoint): p1070[0] = 1050
Default setting 12: "Standard I/O with analog setpoint"
DO 0: p0730, DO 1: p0731
DI 0: r0722.0, …, DI 2: r0722.2
AI 0: r0755[0]
Speed setpoint (main setpoint): p1070[0] = 755[0]
Converter with control units CU240D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34262100B AB
55