Setting functions
8.3 Setpoints
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
121
Table 8- 3 Setting the MOP as setpoint source
p1070 = 1050
Interconnecting the main setpoint with MOP.
Motorized potentiometer, setpoint higher
Interconnect these commands with
signals of your choice.
Motorized potentiometer, setpoint lower
Adapting the behavior of the motorized potentiometer
Figure 8-9 Function chart of motorized potentiometer
To Next Page
Loading...
