Adapt inputs and outputs
6.1 Digital inputs
Converter with control units CU250D-2
80 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Digital inputs
Changing the function of a digital input
Interconnect the status parameter of the digital input with a
binector input of your choice.
Binector inputs are marked with "BI" in the parameter list of
the List Manual.
Table 6- 1 Binector inputs (BI) of the inverter (selection)
Command data set selection CDS bit 0
Motorized potentiometer, setpoint, lower
Flying restart enable signal source
Unconditionally release holding brake
Unconditionally close holding brake
Fixed speed setpoint selection bit 0
Technology controller enable
p1021 Fixed speed setpoint selection bit 1 p3330 Two-wire/three-wire control, control
command 1
p1022 Fixed speed setpoint selection bit 2 p3331 Two-wire/three-wire control, control
p1023 Fixed speed setpoint selection bit 3 p3332 Two-wire/three-wire control, control
Motorized potentiometer, setpoint, raise
A complete list of the binector outputs is provided in the List Manual.
Changing the function of a digital input - example
In order to switch on the motor with digital input DI
2, you have
to connect the status parameter of DI
2 to p0840: Set
You can debounce the digital input signal using parameter p0724.
For more information, see the parameter list and the function block diagrams 2210 ff of the
List Manual.
To Next Page
Loading...
