Commissioning
5.5 Basic commissioning with STARTER
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
71
The basic commissioning of the inverter comprises the following steps:
1. Starting basic commissioning
2. Configuring a drive
3. Loading the configured data into the drive
Starting basic commissioning
Procedure
To start the basic commissioning, proceed as follows:
1. In STARTER select the drive you wish to commission.
2. Start the wizard for the device configuration:
You have started the basic commissioning.
To Next Page
Loading...
