Commissioning
5.5 Basic commissioning with STARTER
Converter with control units CU250D-2
70 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Setting the USB interface
Procedure
Proceed as follows to set the USB interface in STARTER:
1. In this case set the "Access point" to "DEVICE (STARTER, Scout)" and the "PG/PC
interface" to "S7USB".
2. Press the "Update" button.
You have set the USB interface.
STARTER now shows the inverters connected via USB.
To Next Page
Loading...
