Setting functions
8.6 Basic positioner and position control
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
181
Set reference point
Description
Position the load, e.g. using the "jog" function, at the reference position in the machine.
Figure 8-32 Set reference point
Activate 'set home position'
Precondition
You have selected the "Homing" screen.
To activate 'set home position', proceed as follows:
1. Interconnect this bit with the corresponding signal of your machine.
If the axis is stationary, with the signal change 0 → 1, the inverter sets its actual position
value to the reference point coordinate.
For this function, all of the other signals are of no significance.
2. In STARTER, proceed in the expert list and set p2599 to the reference point coordinate.
You have now activated 'set home position'.
To Next Page
Loading...
