Siemens SINAMICS G120D - Backing Up and Transferring Settings Using STARTER

Backing up data and series commissioning
9.2 Backing up and transferring settings using STARTER
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
263
9.2
Backing up and transferring settings using STARTER
With the supply voltage switched on,
you can transfer the converter settings
from the converter to a PG/PC, or the
data from a PG/PC to the converter.
This requires you to have installed the
STARTER commissioning
tool on your
PG/PC.
You will find additional information about STARTER in Chapter:
Commissioning tools
(Page 25).
Inverter
→
PC/PG
Procedure
To back up the settings, proceed as follows:
1. Go online with STARTER :
.
2. Select the button "Download project to PG":
.
3. To save the data in the PG, select the button:
.
4. Go offline with STARTER :
.
You have backed up the settings.
PC/PG
→
inverter
The procedure depends on whether you also transfer settings of safety functions or not.
Procedure without enabled safety functions
To load the settings from the PG to the inverter, proceed as follows:
1. Go online with STARTER :
.
2. Select the button "Download project to target system":
.
3. To save the data in the inverter so that it is not lost when the power fails, select the "Copy
RAM to ROM" button:
.
4. Go offline with STARTER :
.
You have transferred the settings from the PG to the inverter.