Setting functions
8.8 Application-specific functions
Converter with control units CU250D-2
222 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Switching units with STARTER
Precondition
The inverter must be in the offline mode in order to change over the units.
STARTER shows whether you change settings online in the inverter or change offline in the
PC (
/ ).
You switch over the mode using the adjacent buttons
in the menu bar.
To change over the units with STARTER, proceed as follows:
1. Select the configuration
2. Go to the "Units" tab in the configuration screen form to change over the units
3. Changing over the system of units
4. Select process variables of the technology controller
5. Adapting to the line supply
To Next Page
Loading...
