Setting functions
8.6 Basic positioner and position control
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
173
6. Specify the reference point coordinate.
7. Specify the reference point offset.
8. Specify the max. permissible distance to the reference cam in step 1 of active
referencing.
9. If a reference cam is available: Define the maximum permitted distance to the zero mark.
10.If no reference cam is available: Define the tolerance for travel to the zero mark.
11.Close the screen form.
You have set the USB reference point approach.
To Next Page
Loading...
