Setting functions
8.6 Basic positioner and position control
Converter with control units CU250D-2
Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
207
In some applications it is sufficient if the inverter moves the axis for each task in the same
way, absolute or relative to the position setpoint. This approach can be achieved with fixed
setpoints.
To set the fixed setpoints, proceed as follows:
1. Select the button for configuring the fixed setpoint:
2. Set the values suitable to your application:
You have set the fixed setpoints.
To Next Page
Loading...
