Alarms, faults and system messages
11.6 List of alarms and faults
Converter with control units CU250D-2
324 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
Battery voltage pre-alarm
Replace the battery in the encoder.
F32905 Parameterizing error
• Check whether the connected encoder type matches the encoder that
has been parameterized.
• Correct the parameter specified by the fault value (r0949) and p0187.
A32915 Configuration error When the fine resolution Gx_XIST2 is configured, the encoder identifies a
maximum possible absolute position actual value (r0483) that can no
longer be represented within 32 bits. Remedy: Check the encoder data.
For further information, please refer to the List Manual.
To Next Page
Loading...
