Appendix
A.4 Handling STARTER
Converter with control units CU250D-2
348 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
In this area, you can set how the measurement results are displayed.
● Repeating measurements
This places the measurements that you wish to perform at different times above one
other.
● Arrange the curves in tracks
This means you define whether the trace of all measured values is displayed with respect
to a common zero line – or to separate zero lines.
● Measuring cursor on
This allows you to analyze the measuring intervals in more detail.
Figure A-2 Trace dialog box
To Next Page
Loading...
