Siemens SINAMICS G120D - Page 74

Commissioning
5.5 Basic commissioning with STARTER
Converter with control units CU250D-2
74 Operating Instructions, 04/2014, FW V4.7, A5E34261542B AA
10.
Select the encoder that you use for position sensing.
11.
You may skip this screen initially. The settings are explained in the
context of commissioning of the basic positioner in the section:
Basic
positioner and pos
ition control (Page 147).
12.
Set the check mark for "RAM to ROM (save data in the drive)" in order
to save
your data in the converter so that it is not lost when the power
fails
①.
13.
Close basic commissioning ②
.
You have entered all of the data that is necessary for the basic commissioning of your
converter.