Commissioning
5.3 Procedure for commissioning via STARTER
Drive converter cabinet units
138 Operating Instructions, 07/07, A5E00288214A
Note
Click Template to open another selection screenform where you can choose the motor used
in your application from a long list of standard motor types. Select a motor from the list to
enter the data stored in the system for that motor automatically in the data fields.
NOTICE
You should only check the "Do you want to enter equivalent circuit diagram data?" box if
the data sheet with equivalent circuit diagram data is available. If any data is missing, an
error message will be output when the system attempts to load the drive project to the
target system.
23. Click Continue >.
To Next Page
Loading...
