Siemens SINAMICS S150 - Profidrive NAMUR Default Setting_G150_S150

Operation
6.4 Command sources
Drive converter cabinet units
Operating Instructions, 07/07, A5E00288214A
193
6.4.4 "PROFIdrive NAMUR" default setting_G150_S150
Prerequisites
The NAMUR terminal block (option B00) is installed in the cabinet unit.
The "PROFIdrive" default setting was chosen during commissioning:
• STARTER:
"PROFIdrive Namur"
• AOP30:
"10: PROFIdrive Namur"
Command sources
U0DVWHUFRQWURODFWLYH
5(027(352),GULYH1$085
/2&$/2SHUDWRUSDQHO
/2&$/5(027(NH\
,QWHUQDOFRQWURO
&DELQHWRSHUDWRUSDQHO
352),%86
1DPXUWHUPLQDOV;
Figure 6-15 Command sources - AOP30←→PROFIdrive NAMUR
Priority
The priority of the command sources is shown in the diagram "Command sources - AOP30
←→ PROFIdrive NAMUR".
Note
The EMERGENCY STOP and motor protection signals are always active (regardless of the
command source).
All of the supplementary setpoints are deactivated for LOCAL master control.