Siemens SINAMICS S150 - Fixed Speed Setpoints

Operation
6.5 Setpoint sources
Drive converter cabinet units
198 Operating Instructions, 07/07, A5E00288214A
Parameters
• p1030
Motorized potentiometer, configuration
• p1037
Motorized potentiometer, maximum speed
• p1038
Motorized potentiometer, minimum speed
• p1047
Motorized potentiometer, ramp-up time
• p1048
Motorized potentiometer, ramp-down time
• r1050
Motorized potentiometer, setpoint after the ramp-function generator
6.5.3 Fixed speed setpoints
Description
Three variable fixed speed setpoints are available. They can be selected via terminals or
PROFIBUS.
Prerequisites
The default setting for the fixed speed setpoints was chosen during commissioning:
• STARTER:
"Fixed setpoint"
• AOP30:
"4: Fixed setpoint"
Signal flow diagram
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
$FWLYH
)6:ELW
)6:ELW




S
S
S

U
Figure 6-19 Signal flow diagram: Fixed speed setpoints