Siemens SINAMICS S150 - Page 184

Operation
6.3 Basic information about the drive system
Drive converter cabinet units
184 Operating Instructions, 07/07, A5E00288214A
%2%LQHFWRURXWSXW
&2&RQQHFWRURXWSXW
6LJQDOVRXUFH
%,%LQHFWRULQSXW
&,&RQQHFWRULQSXW
6LJQDOVLQN
&2ZLWKLQGH[
,QGH[
&2ZLWKRXWLQGH[
S[[[[\

%,
U
%2
U
S[[[[\
>@
&,
>@
U
U
>@
>@
U
>@
U
S[[[[\

&,
Figure 6-5 Interconnecting signals using BICO technology
Note
A signal source (BO) can be connected to any number of signal sinks (BI).
A signal sink (BI) can only ever be connected to one signal source (BO).
The BICO parameter interconnection can be implemented in different command data sets
(CDS). The different interconnections are activated by switching data sets. Interconnections
across drive objects are also possible.
Internal encoding of the binector/connector output parameters
The internal codes are needed, for example, to write BICO input parameters via PROFIdrive.
'HYLFHHJ&8
6HSDUDWHREMHFW
3DUDPHWHUQXPEHU
,QGH[QXPEHU
'ULYH
REMHFW
([DPSOHVLJQDOVRXUFHV
KH[!)L[HG
KH[!)L[HG



%LW
ELQ ELQELQ
ELQ ELQELQ
()&KH[!&2>@
ELQ
GH]
ELQ
GH]
ELQ
GH]
Figure 6-6 Internal encoding of the binector/connector output parameters