Operation
6.8 PROFINET IO
Drive converter cabinet units
240 Operating Instructions, 07/07, A5E00288214A
Settings in STARTER
The following settings are required in STARTER for communication via PROFINET:
● Extras -> Set PG/PC interface
Figure 6-36 Set the PG/PC interface
Assignment of the IP address and the name for the PROFINET interface of the drive unit
Use the STARTER to assign an IP address and a name to the PROFINET interface (e.g.
CBE20).
Requirement:
● Connect the direct Ethernet cable from the PG/PC to the PROFINET interface of the
CU320 Control Unit.
● Switch on Control Unit CU320
The accessible nodes must be searched in the STARTER:
● Project -> Accessible nodes
Subsequently the nodes found are displayed in the interactive screen.
To Next Page
Loading...
