Task navigation
SINAMICS V-ASSISTANT Online Help
60 Operating Manual, 04/2017, A5E36618042-003
Setting the position setpoint in EPOS control mode
Maximum acceleration in 1000 LU/s
2
(default value: 100)
Maximum acceleration in 1000 LU/s
2
(default value: 100)
Working mode overview for EPOS setpoint settings
Three working modes are available for your selection. Whatever mode you select, the actual
velocity is affected by the maximum acceleration and deceleration. You can enter the
desired maximum acceleration and deceleration in areas
① and ② respectively.
Configure your desired working mode on the corresponding panel:
● Traversing block
To Next Page
Loading...
