ï›™ Siemens AG 2000. All rights reserved
0-10
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
0
Contents 04.00
0
12.1.2 Use of M commands ............................................................................................. 12-419
12.2 Automatic path segmentation..................................................................................... 12-420
12.2.1 Path segmentation for path axes .......................................................................... 12-421
12.2.2 Path segmentation for single axes........................................................................ 12-422
12.2.3 Programming examples ........................................................................................ 12-424
Additional Functions 13-427
13.1 Axis functions AXNAME, SPI, ISAXIS ....................................................................... 13-428
13.2 Learn compensation characteristics: QECLRNON, QECLRNOF.............................. 13-429
13.3 Synchronized spindle ................................................................................................. 13-431
13.4 EG: Electronic gear (SW 5 and higher)...................................................................... 13-441
13.4.1 Define electronic gear: EGDEF............................................................................. 13-441
13.4.2 Activate electronic gear......................................................................................... 13-443
13.4.3 Deactivate electronic gear..................................................................................... 13-445
13.4.4 Delete definition of an electronic gear................................................................... 13-446
13.4.5 Revolutional feedrate (G95)/electronic gear (SW 5.2) .......................................... 13-446
13.4.6 Response of EG at Power ON, RESET, mode change, block search.................. 13-447
13.4.7 The electronic gear's system variables ................................................................. 13-447
13.5 Extended stopping and retract (as of SW 5) .............................................................. 13-447
13.5.1 Drive-independent reactions ................................................................................. 13-448
13.5.2 Possible trigger sources........................................................................................ 13-449
13.5.3 Logic gating functions: Source/reaction operation ................................................ 13-450
13.5.4 Activation............................................................................................................... 13-450
13.5.5 Generator operation/DC link backup..................................................................... 13-451
13.5.6 Drive-independent stop ......................................................................................... 13-451
13.5.7 Drive-independent retract...................................................................................... 13-452
13.5.8 Example: Using the drive-independent reaction ................................................... 13-453
13.6 Link communication (SW 5.2 and higher).................................................................. 13-454
13.7 Axis container (SW 5.2 and higher) ........................................................................... 13-457
13.8 Program execution time/Workpiece counter (as from SW 5.2) ................................. 13-459
13.8.1 Program runtime ................................................................................................... 13-459
13.8.2 Workpiece counter ................................................................................................ 13-460
User Stock Removal Programs 14-463
14.1 Supporting functions for stock removal...................................................................... 14-464
14.2 Contour preparation: CONTPRON............................................................................. 14-465
14.3 Contour decoding: CONTDCON (as of SW 5.2)........................................................ 14-472
14.4 Intersection of two contour elements: INTERSEC ..................................................... 14-476
To Next Page
Loading...
Need help?
General
