Siemens SINUMERIK 840D

3
08.97 File and Program Management
3.6 Automatic activation of GUDs and MACs
(
SW 4.4 and hi
g
her
)
3
840D
NCU 571
840D
NCU 572
NCU 573
FM-NC 810D 840Di
Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA)
−
04.00 Edition
3-137
3.6 Automatic activation of GUDs and MACs (SW 4.4 and higher)
Function
The definition files for GUD and macro definitions
are edited
•
in the Services operating area for the MMC
102/103.
If a definition file is edited in the NC, when exiting the
Editor you are prompted whether the definitions are
to be set active.
Example:
"Do you want to activate the definitions from file
GUD7.DEF?"
"OK"
Æ Then a prompt is displayed whether the
currently active data are to be saved.
"Do you want to save the previous data
in the definitions?"
"OK" Æ The GUD blocks of the definition file
to be edited are saved, the new
definitions are activated and the
saved data are imported again.
"Cancel" Æ The new definitions are activated,
the old data cleared.
"Cancel" Æ The changes in the definition file
are discarded, the associated data
block is not changed.
Unload
If a definition file is unloaded, the associated data
block is deleted after a query is displayed.