Siemens SINUMERIK 840D

8
04.00 Tool Offsets
8

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA)
−
04.00 Edition
8-263
Tool Offsets
8.1 Offset memory .............................................................................................................. 8-264
8.2 Language commands for tool management ................................................................. 8-266
8.3 Online tool offset PUTFTOCF, PUTFTOC, FTOCON, FTOCOF ................................. 8-269
8.4 Maintain tool radius compensation at constant level, CUTCONON
(SW 4 and higher)......................................................................................................... 8-275
8.5 Activate 3D tool tool offsets .......................................................................................... 8-278
8.6 Tool orientation ............................................................................................................. 8-286
8.7 Free assignment of D numbers, cutting edge number CE (as of SW 5) ...................... 8-291
8.7.1 Check D numbers (CHKDNO) .................................................................................. 8-292
8.7.2 Renaming D numbers (GETDNO, SETDNO) ........................................................... 8-293
8.7.3 T numbers for the specified D number (GETACTTD)............................................... 8-294
8.7.4 Set final D numbers to invalid.................................................................................... 8-295
8.8 Toolholder kinematics................................................................................................... 8-296