Siemens SINUMERIK 840D

13
Additional Functions 12.98
13.3 S
y
nchronized s
p
indle
13
840D
NCU 571
840D
NCU 572
NCU 573
840Di

Siemens AG 2000. All rights reserved
13-436
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
Block change behavior
The following options can be selected during
definition of the coupling to determine when the
block change takes place:
"NOC"
Immediately (default)
"FINE"
At "Synchronization fine"
"COARSE"
At "Synchronization coarse"
"IPOSTOP"
At IPOSTOP (i.e. after synchronization
on the setpoint side)
It is sufficient to specify the characters typed in bold
when specifying the block change method.
The block change method is modal!
Coupling type
"DV"
Setpoint coupling between FS and
LS (default)
"AV"
Actual-value coupling between FS
and LS
The coupling type is modal.
Caution
The coupling type may only be changed when the
coupling is deactivated!