Siemens SINUMERIK 840D

13
Additional Functions 12.98
13.3 S
y
nchronized s
p
indle
13
840D
NCU 571
840D
NCU 572
NCU 573
840Di

Siemens AG 2000. All rights reserved
13-438
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
Delete couplings, COUPDEL
An existing user-defined synchronized spindle
coupling must be deleted if a new coupling
relationship is to be defined and all user-configurable
couplings (1 or 2) are already defined.
N … COUPON (S2,S1)
SPI(2) = following spindle, SPI(1) = leading spindle
A coupling can only be deleted if it has been
deactivated first (COUPOF).
A permanently configured coupling cannot be
deleted by means of COUPDEL.
Reset coupling parameters, COUPRES
Language instruction "COUPRES" is used to
•
activate the parameters stored in the machine
data and setting data (permanently defined
coupling) and
•
activate the presettings (user-defined coupling)
The parameters programmed with COUPDEF
(including the transformation ratio) are subsequently
deleted.
N … COUPRES (S2,S1)
S2 = following spindle, S1 = leading spindle