Siemens SINUMERIK 840D

15
12.98 Tables
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-487
CLAL Clear alarm INT Parameter: Alarm
number
CLEARM Reset one/several markers for channel
coordination
INT,
1 - n
Does not influence
machining in own
channel
CLGOF Const. workpiece speed for centerless grinding OFF
CLGON Const. workpiece speed for centerless grinding ON
CLRINT Deselect interrupt INT Parameter:
Interrupt number
CMIRROR Mirror on a coordinate axis FRAME
COMPOF
1,6
Compressor OFF m30
COMPON
6
Compressor ON m30
COMPCURV
Compressor ON constant curve polynomials m 30
CONTPRON
Activate contour preparation
(contour preparation ON)
m49
COS Cosine (trigon. function) Real
COUPDEF Definition ELG group / synchronous spindle
group
(couple definition)
String Block change
(software)
response:
NOC: no software
control,
FINE/COARSE:
software on
"Synchronization
fine / coarse",
IPOSTOP: software
on setpoint-
dependent
termination of
overlaid movement
COUPDEL Delete ELG group (couple delete)
COUPOF ELG group / synchronous spindle pair OFF (couple OFF)
COUPON ELG group / synchronous spindle pair ON (couple ON)
COUPRE
S
Reset ELG group
(couple reset)
Programmed
values invalid;
machine data
values valid
CP Path movement (continuous path) m49
CPRECOF
1,6
Programmable contour precision OFF m39
CPRECON
6
Programmable contour precision ON m39
CPROT Channel-specific protection zone ON/OFF
CPROTDEF
Channel specific protection area definition