Siemens SINUMERIK 840D

15
Tables 12.98
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
15-508
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
Legend:
1
Default setting at start of program (in delivery state of control system provided that another setting is not programmed).
2
The group numbering corresponds to the numbering in table "Overview of instructions" in Section 11.3
3
Absolute end points: Modal; incremental end points: Non-modal; otherwise modal/non-modal depending
on syntax of G function
4
IPO parameters act incrementally as arc centres. They can be programmed in absolute mode with AC. When they have other
meanings (e.g. pitch), the address modification is ignored.
5
Vocabulary word does not apply to SINUMERIK FM-NC/810D
6
Vocabulary word does not apply to SINUMERIK FM-NC/810D/NCU571
7
Vocabulary word does not apply to SINUMERIK 810D
8
The OEM user can incorporate two extra interpolation types and modify their names.
9
Vocabulary word applies only to SINUMERIK FM-NC
10
The extended address block format may not be used for these functions.