Siemens SINUMERIK 840D - Page 584

A
Appendix 04.00
Index
A

Siemens AG 2000. All rights reserved
A-584
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
CTABDEF 9-312
CTABEND 9-312
CTABINV 9-315
Current
Angular offset 13-439
Coupling status following spindle 13-439
Current block display 2-107
Curve parameter 5-169
Curve tables 9-311
CUT 14-477
Cutter
Reference point (FH) 8-284
Tip (FS) 8-284
Cutting edge number 8-291
Cycles
Setting parameters for user cycles 2-113
Cylinder surface curve
transformation 7-241, 7-245
Cylinder surface transformation
Offset contour normal OFFN 7-243
D
D numbers
Check 8-292
Determine T number 8-294
Free assignment 8-291
Rename 8-293
DC link backup 13-451
Deactivate transformation: TRAFOOF 7-253
Deactivate/reactivate interrupt routine 1-71
Deactivating frames 6-208
Deactivation position 13-437
Defining user data 3-131
Degrees 9-311
DELETE 1-83
Delete couplings 13-438
Delete distance-to-go 5-180
Delete distance-to-go with preparation 10-362
Deletion of distance-to-go 10-362, 11-402
Denominator polynomial 5-167
DRF offset 6-205
Drive-independent reactions 13-448
Drive-independent retract 13-452
Drive-independent stop 13-451
Dwell time 1-67
E
EG
Electronic gear 13-441
Electronic gear 13-441
End of program 10-392
Endless program 1-62
Error check-back 14-465, 14-472
Error responses 10-385
Euler angle 8-286
Evaluation function 10-367
EXECTAB 14-464
EXECUTE 4-140
Executing an external subprogram 2-111
EXTCALL 2-111
Extended measuring function 5-177, 7-233
Extended stopping and retract 13-447
External zero offset 6-206
F
F word polynomial 5-170
Face milling 7-226
Face turning
External machining 14-465
Internal machining 14-465
FAxis 9-302, 9-307, 9-311, 9-319
Feed
Axial 10-377
FGROUP
Axes 5-169
FIFO variable 10-357
Fine offset 6-204
Flag variables 10-353
Following axis 9-319
FOR 1-59
Frame calculation 6-209
Frame chaining 6-201
Frame variable
Coordinate transformation call 6-192
Frame variables 6-192