Siemens SINUMERIK 840D

A
04.00 Appendix
Index
A

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
A-587
Program run with preprocessing memory 9-330
Program runtime 13-459
Programmable motion end criterion 5-188
Protection levels for user data 3-135
Protection zones 4-139
Activating, deactivating protection zones 4-144
Contour definition of protection zones 4-142
Define channel-specific protection zones 4-140
Define machine-specific protection zones 4-140
Defining protection zones 4-141
Punching 12-416, 12-420
Punching on 12-416
Q
Quadrant error compensation
Activate learning process 13-430
Deactivate learning process 13-430
Subsequent learning 13-430
Quantity of parts, fixed 1-62
R
R 15-509
R parameters 10-355
R parameters (list) 15-509
READ 1-84
Read-in disable 10-360
Real-time variables 10-350
Relief cut 14-465
Relief cut elements 14-466
REPEAT 1-60
Repositioning 10-394
Repositioning on contour 9-332
Approach along a straight line 9-335
Approach along quadrant 9-335
Approach along semi-circle 9-336
Approach with new tool 9-334
Repositioning point 9-333
Reset 10-391
Resolved kinematics 8-296
Reversal
Area 11-404
Point 11-404
Rotary angles a1, a2 8-296
Rotary axes
Distance vectors l1, l2 8-296
Rotary axis
Direction vectors V1, V2 8-296
Rotatable tool table l4 8-296
Rounding 5-170
RPY angle 8-286
Runtime response 1-60
S
SBLON 2-108
Search for character 1-51
Selecting a single characters 1-54
Selection of a substring 1-53
Servo parameter block programmable 5-189
Set actual value 10-379
Setpoint coupling 13-431
Settable path reference 5-169
Setting data 11-398
Side angle 7-224
Single axis motion 12-422
Single block suppression 2-108
Singular positions 7-229
Spark-out stroke 11-402
Speed ratio 13-435
Spindle motions 10-380
Spindle transfer
GET 1-76
RELEASE 1-76
Spline grouping 5-157
Spline interpolation 5-151, 5-169
A spline 5-152
B spline 5-153
C spline 5-154
Compressor 5-157
Start/stop axis 10-376
Station/position change 13-457
Status of coupling 9-322
Stock removal 14-464
Stopping and retract
Extended 13-447
String length 1-51