EasyManuals Logo

Siemens SINUMERIK 840D Programming Guide

Siemens SINUMERIK 840D
598 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
ï›™ Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
0-7
0
04.00 Contents
0
5.6 Measurements with touch trigger probe, MEAS, MEAW ............................................. 5-174
5.7 Extended measuring function MEASA, MEAWA, MEAC (SW 4 and higher, option) .. 5-177
5.8 Special functions for OEM users.................................................................................. 5-187
5.9 Programmable motion end criterion (SW 5.1 and higher) ........................................... 5-188
5.10 Programmable servo parameter block (SW 5.1 and higher) ....................................... 5-189
Frames 6-191
6.1 Coordinate transformation via frame variables ............................................................ 6-192
6.2 Frame variables/assigning values to frames ............................................................... 6-197
6.3 Coarse/fine offset......................................................................................................... 6-204
6.4 DRF offset.................................................................................................................... 6-205
6.5 External zero offset ...................................................................................................... 6-206
6.6 Programming Preset offset, PRESETON .................................................................... 6-207
6.7 Deactivating frames ..................................................................................................... 6-208
6.8 Frame calculation from three measuring points in the area, MEAFRAME .................. 6-209
6.9 NCU-global frames (SW 5 and higher)........................................................................ 6-212
6.9.1 Channel-specific frames ......................................................................................... 6-213
6.9.2 Frames active in the channel.................................................................................. 6-215
Transformations 7-219
7.1 Three, four and five-axes transformation: TRAORI ..................................................... 7-220
7.1.1 Programming the tool orientation............................................................................ 7-223
7.1.2 Orientation axes reference, ORIWKS, ORIMKS .................................................... 7-228
7.1.3 Singular positions and how they are handled ......................................................... 7-229
7.1.4 Orientation axes (SW 5.2 and higher) ................................................................... 7-230
7.1.5 Cartesian PTP travel (SW 5.2 and higher) ............................................................. 7-233
7.2 Milling machining on turned parts: TRANSMIT............................................................ 7-238
7.3 Cylinder surface transformation: TRACYL................................................................... 7-241
7.4 Inclined axis: TRAANG ................................................................................................ 7-247
7.5 Supplementary conditions when selecting a transformation........................................ 7-251
7.6 Deactivate transformation: TRAFOOF......................................................................... 7-253
7.7 Chained transformations.............................................................................................. 7-254
7.8 Switchable geometry axes, GEOAX ............................................................................ 7-257

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals