Siemens SINUMERIK 840D

2
12.98 Subprograms, Macros
2

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA)
−
04.00 Edition
2-91
Subprograms, Macros
2.1 Using subprograms......................................................................................................... 2-92
2.2 Subprogram with SAVE mechanism............................................................................... 2-94
2.3 Subprograms with parameter transfer ........................................................................... 2-95
2.4 Calling subprograms ..................................................................................................... 2-99
2.5 Subprogram with program repetition............................................................................ 2-103
2.6 Modal subprogram, MCALL ......................................................................................... 2-104
2.7 Calling the subprogram indirectly................................................................................. 2-105
2.8 Calling subprogram with path specification and parameters, PCALL.......................... 2-106
2.9 Suppressing current block display, DISPLOF.............................................................. 2-107
2.10 Single block suppression, SBLOF, SBLON (SW 4.3 and higher)................................ 2-108
2.11 Executing an external subprogram (SW 4.2 and higher)............................................. 2-111
2.12 Cycles: Setting parameters for user cycles.................................................................. 2-113
2.13 Macros ......................................................................................................................... 2-118