Introduction
1
1.1 Purpose of this documentation
These instructions contain all information required to commission and use the device. Read the
instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2 Scope of documentation
Article no. Product
6DR50.. SIPART PS2, 2-wire (4 mA to 20 mA), without HART
6DR51.. SIPART PS2, 2-wire (4 mA to 20 mA), with HART
6DR52.. SIPART PS2, 2-wire, 3-wire, 4-wire (0/4 to 20 mA), with HART
6DR53.. SIPART PS2, 2-wire, 3-wire, 4-wire (0/4 mA to 20 mA), without HART
6DR5910-* SIPART PS2 without basic electronics with Position Transmitter and
pneumatics unit
A5E00151560 19" slide-in module with operating and control unit; 4 to 20 mA with 2-wire
connection
6DR4004-6A / -8A Digital I/O Module (DIO)
6DR4004-6F / -8F Analog Input Module (AIM)
6DR4004-6J / -8J Analog Output Module (AOM)
6DR4004-6G / -8G Inductive Limit Switches (ILS)
6DR4004-6K / -8K Mechanic Limit Switches (MLS)
6DR4004-5L / -5LE Internal NCS module
6DR4004-6N* / -8N* NCS sensor
6DR4004-1ES ... -4ES Position Transmitter
6DR4004-1R / -2R / -1RN /
-2RN
Pneumatic terminal strip
6DR4004-8D and
TGX:16300-1556
Installation for NAMUR part-turn actuators
6DR4004-8V / -8L / -8VK /
-8VL
Mounting kit for NAMUR linear actuator
6DR4004-1RJ/K/P/Q and
6DR4004-2RJ/K/P/Q
Booster
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE 13
To Next Page
Loading...
Need help?
General
