Siemens SIPART PS2 series User Manual

Spare parts/accessories/scope of delivery
14
14.1 Overview
WARNING
Assembling the components
When assembling components, ensure that only those positioners and option modules are
combined with each other that are approved for the corresponding operating range.
These conditions particularly apply to safe operation of the positioner in hazardous areas.
Observe the applicable certificates and approvals or the "Technical data (Page 239)".
Basic version
The positioner can be delivered for:
● Double-acting actuators
● Single-acting actuators
The positioner and its option modules are delivered as separate units and with different
versions for the operation in:
● Hazardous environments and atmospheres
● Non-hazardous environments and atmospheres
Enclosure
The electronic unit with display, the position feedback, and the pneumatic block are integrated
in the enclosure.
The enclosure is available in the following versions:
● Polycarbonate enclosure for single-acting and double-acting actuators
● Aluminum enclosure for single-acting or double-acting actuators
● Stainless steel enclosure for single and double-acting actuators
● Flameproof enclosure for single and double-acting actuators
Options
The following option modules are available for the positioner:
● Analog Output Module (AOM) 6DR4004-6J / -8J: 2-wire current output 4 to 20 mA for
position feedback
● Digital I/O Module (DIO) 6DR4004-6A / -8A: 3 digital outputs and 1 digital input
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE 261

Siemens SIPART PS2 series Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Type	Electropneumatic
Input Signal	4-20 mA
Stroke Range	3 to 200 mm
Rotary Range	30 to 100°
Mounting	Linear or rotary actuators
Certifications	ATEX, IECEx, FM, CSA