Siemens SIPART PS2 series User Manual

Edition Note
01/2019
● Changes for FW 5.02.00, HART device revision 7
● Ex "nA" (non-sparking equipment) is replaced by Ex "ec" (increased safety)
● Option -Z P01 Extended diagnostics supported by pressure sensors
– Parameter assignment: U.\\PRES (Page 188)
– Diagnostics values: 60.PZ, 63.PZMAX und 64.N_Min (Page 228)
– Online diagnostics: Error codes 17 to 19 (Page 234)
Section "Installing/mounting (Page 37)"
– New markings on the lever with carrier pin (Page 40)
– Revised section "Setting and locking the transmission ratio (Page 48)"
● Section "Pneumatic connection (Page 90)"
– Revised section "Behavior in case of failure of the electrical auxiliary power
and/or the supply pressure PZ (Page 93)"
● Section "Commissioning (Page 105)"
– Revised section "Setting the friction clutch (Page 115)"
● Section "Service and maintenance (Page 197)"
– Section "Replacing the basic electronics" with the "Fail in Place" function has
been revised and is now called "Replace basic electronics (Page 200)"
– New section "Replace pneumatic block (Page 202)" and "Replace the pres‐
sure sensor module (Page 203)"
● Section "Technical data (Page 239)"
– Explosion protection (Page 243) restructured and contains a breakdown of
the article number
● Section "Spare parts/accessories/scope of delivery (Page 261)" extended
1.4 Designated use
Use the device in accordance with the information on the nameplate and in the Technical data
(Page 239).
1.5 Product compatibility
The following table describes the compatibility between document output, device revision,
engineering system and associated Electronic Device Description (EDD).
Manual
edition
Comments Device revision Compatible version of device integration package
11/2019 New manual
edition
FW: 5.02.00 or higher
Device revision 7 or higher
SIMATIC PDM V9.0 EDD: 23.00.00 or higher
SIMATIC PDM V8.2 SP1 EDD: 23.00.00 or higher
AMS Device Manager V12.5 EDD: 23.00.00 or higher
SITRANS DTM V4.1 EDD: 23.00.00 or higher
Field communicator EDD: 23.00.00 or higher
Introduction
1.5 Product compatibility
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE 15

Siemens SIPART PS2 series Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Type	Electropneumatic
Input Signal	4-20 mA
Stroke Range	3 to 200 mm
Rotary Range	30 to 100°
Mounting	Linear or rotary actuators
Certifications	ATEX, IECEx, FM, CSA