Siemens SIPART PS2 series - Overview of Configuration; Description of Operating Modes

See also
Display (Page 95)
6.2.3 Overview of configuration
The following picture illustrates the handling of operating modes such as "Configuration" and
"Initialization mode":
VLPXOWDQHRXVVLPXOWDQHRXV
VLPXOWDQHRXVVLPXOWDQHRXV
XQWLO
Figure 6-4 Overview of the "Configuration" operating mode
6.2.4 Description of operating modes
P manual mode
Note
Delivery state
The "P manual mode" is preset for the positioner in the delivery state.
The display of the positioner shows the current potentiometer position in the upper line. "NOINI"
blinks in the second line of the display.
Move to the actuator with the or buttons.
Switch to "Configuration" mode to adapt the actuator to the positioner.
Alarms or position feedbacks can be triggered after initializing the positioner completely.
Operating
6.2 Operating modes
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE 99