Siemens SIPART PS2 series User Manual

5.3.2.2 Integrated pneumatic connection ...........................................................................................91
5.3.3 Pneumatic connection in the flameproof enclosure ...............................................................92
5.3.4 Behavior in case of failure of the electrical auxiliary power and/or the supply pressure PZ ......93
5.4 Restrictors ..............................................................................................................................93
6 Operating....................................................................................................................................................95
6.1 Operating elements................................................................................................................95
6.1.1 Display ...................................................................................................................................95
6.1.2 Buttons ...................................................................................................................................96
6.1.3 Firmware version ...................................................................................................................97
6.2 Operating modes....................................................................................................................98
6.2.1 Overview of operating modes ................................................................................................98
6.2.2 Changing the operating mode................................................................................................98
6.2.3 Overview of configuration.......................................................................................................99
6.2.4 Description of operating modes .............................................................................................99
6.2.5 Optimization of controller data .............................................................................................101
7 Commissioning .........................................................................................................................................105
7.1 Basic safety instructions.......................................................................................................105
7.2 Overview ..............................................................................................................................107
7.3 Sequence of automatic initialization.....................................................................................109
7.4 RUN 1 sequence..................................................................................................................110
7.5 RUN 2 sequence with linear actuators.................................................................................111
7.6 RUN 2 sequence with part-turn actuators ............................................................................112
7.7 RUN 3 to 5 sequence...........................................................................................................113
7.8 Setting the friction clutch ......................................................................................................115
7.9 Purge air switching...............................................................................................................117
7.10 Commissioning linear actuators ...........................................................................................117
7.10.1 Preparing linear actuators for commissioning ......................................................................117
7.10.2 Automatic initialization of linear actuators ............................................................................119
7.10.3 Manual initialization of linear actuators ................................................................................121
7.11 Commissioning part-turn actuators ......................................................................................124
7.11.1 Preparing part-turn actuators for commissioning .................................................................124
7.11.2 Automatic initialization of part-turn actuators .......................................................................125
7.11.3 Manual initialization of part-turn actuators ...........................................................................126
7.12 Canceling initialization..........................................................................................................129
7.13 Device replacement .............................................................................................................129
8 Parameter assignment .............................................................................................................................133
8.1 Introduction to parameter assignment section .....................................................................133
8.2 Configuration schematic for parameter operating principle..................................................134
8.3 Tabular overview of the parameters.....................................................................................135
8.3.1 Overview of initialization parameters 1 to 5 .........................................................................135
8.3.2 Overview of application parameters 6 to 52.........................................................................136
Table of contents
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE 5

Siemens SIPART PS2 series Specifications

General

Supply Pressure	1.4 to 7 bar (20 to 100 psi)
Enclosure Rating	IP66/NEMA 4X
Type	Electropneumatic
Input Signal	4-20 mA
Stroke Range	3 to 200 mm
Rotary Range	30 to 100°
Mounting	Linear or rotary actuators
Certifications	ATEX, IECEx, FM, CSA