3 Mounting and Commissioning................................................................................................................. 205
3.1 Mounting and Connections............................................................................................. 206
3.1.1 Configuration Information......................................................................................... 206
3.1.2 Hardware Modifications.............................................................................................209
3.1.2.1 Disassembly.........................................................................................................209
3.1.2.2 Connections of the Current Terminals...................................................................212
3.1.2.3 Connections of the Voltage Terminals...................................................................214
3.1.2.4 Interface Modules................................................................................................ 214
3.1.2.5 Reassembly..........................................................................................................217
3.1.3 Installation................................................................................................................ 218
3.1.3.1 General................................................................................................................218
3.1.3.2 Panel Flush Mounting...........................................................................................218
3.1.3.3 Cubicle Mounting.................................................................................................219
3.1.3.4 Panel Surface Mounting....................................................................................... 220
3.2 Checking Connections.....................................................................................................222
3.2.1 Checking the Data Connections of the Interfaces........................................................222
3.2.2 Checking the Protection Data Communication............................................................224
3.2.3 Checking the System Connections............................................................................. 225
3.3 Commissioning............................................................................................................... 227
3.3.1 Test Mode and Transmission Block.............................................................................228
3.3.2 Checking Time Synchronization................................................................................. 228
3.3.3 Testing the System Interface .....................................................................................228
3.3.4 Configuring Communication Modules........................................................................230
3.3.5 Checking the Status of Binary Inputs and Outputs...................................................... 233
3.3.6 Checking the Protection Data Communication............................................................236
3.3.7 Checking Circuit Breaker Failure Protection................................................................ 238
3.3.8 Checking the Instrument Transformer Connections of One Line End...........................239
3.3.9 Checking the Instrument Transformer Connections of Two Line Ends......................... 244
3.3.10 Checking the Pilot Protection for Internal and External Remote Tripping..................... 244
3.3.11 Checking User-defined Functions...............................................................................244
3.3.12 Trip and Close Test with the Circuit Breaker................................................................244
3.3.13 Switching Check for the Configured Equipment......................................................... 245
3.3.14 Triggering Oscillographic Recording for Test...............................................................245
3.4 Final Preparation of the Device........................................................................................247
4 Technical Data.......................................................................................................................................... 249
4.1 General Device Data........................................................................................................250
4.1.1 Analog Inputs............................................................................................................250
4.1.2 Auxiliary Voltage....................................................................................................... 250
4.1.3 Binary Inputs and Outputs......................................................................................... 251
4.1.4 Communication Interfaces.........................................................................................252
4.1.5 Electrical Tests...........................................................................................................254
4.1.6 Mechanical Stress Tests............................................................................................. 256
4.1.7 Climatic Stress Tests.................................................................................................. 256
4.1.8 Service Conditions..................................................................................................... 257
4.1.9 Design.......................................................................................................................257
4.1.10 UL Certification Conditions........................................................................................ 257
4.2 Protection Interfaces and Connections.............................................................................259
Table of Contents
SIPROTEC 4, 7SD80, Manual 15
E50417-G1100-C474-A2, Edition 02.2018
To Next Page
Loading...
Need help?
General
