Index
603
7SA522 Manual
C53000-G1176-C155-3
L
Life Contact 376
Limit Value Handling 526
Limit Value Monitoring 359
Limit values 359
Limits for CFC Blocks 482
Limits for User-defined Functions 482
Line Data 47
Long-term Average Values 355
M
Malfunction Responses 321
Measured Value Acquisition 315
Measured Value Correction 295
Measured Values 477
Measures for Weak and Zero Infeed 144
Measuring the Operating Time of the Circuit
Breaker 421
Mechanical Tests 441
Memory Modules 314
Minimum current 72
Monitoring Function 314, 477
Monitoring with Binary Input 328
Mounting: Panel Surface Mounting 395
N
Nominal Currents 377
Non-delayed Tripping 202
O
Open Pole Detector 336
Operating Interface 435
Operating Modes 261
Operating Time of the Circuit Breaker 421
Operational Annunciations (Buffer: Event Log) 348
Operational Event Log Buffer 485
Operational measured values 484
Optical Fibres 398
Ordering Information 490
Oscillographic Recordings for Test 428
Output relay 346
Output Relays Binary Outputs 434
Overcurrent Stage 3I0> (O/C with DT) 217
Overcurrent Stage 3I0P (IDMT protection with ANSI
characteristics) 219
Overcurrent Stage 3I0P (IDMT protection with IEC
characteristics) 218
Overcurrent Stage I> 215
Overcurrent Stage Ip 215
Overcurrent Stage IP (IDMT protection with ANSI
characteristics) 219
Overcurrent Stage IP (IDMT protection with IEC
characteristics) 218
Overcurrent Stage Iph> (O/C with DT) 217
Overvoltage Negative Sequence System U2 281
Overvoltage Phase-Earth 280
Overvoltage Phase–Phase 280
Overvoltage Positive Sequence System U1 280,
283
Overvoltage Protection 271
P
Parallel Line Measured Value Correction 70, 73
Parallel Line Mutual Impedance 52
Permissive Overreach Transfer Trip (POTT) 132
Permissive Underreach Transfer Trip with Zone Ac-
celeration Z1B (PUTT) 129
Phase Current Stabilization 158, 171
Phase Rotation Field Check 413
Phase Segregated Initiation 303
Phase Selection 202
Phase Selector 161
Pickup Logic for the Entire Device 337
Pickup value (SOTF-O/C)) 225
Pickup values (Freq.) 291
Polarity Check for for the Current Measuring Input
I4 418
Pole Discrepancy Supervision 308, 312
Power Metering 360
Power supply 433
Power Swing Detection 447
Power Swings 289
Protection Data Interfaces and Communication
Topology 462
R
Rack Mounting 393
Reading / Setting / Resetting 350
Real Time Clock and Buffer Battery 485
Reclosing Cycle 250, 251, 252
Reduced Dead Time 248
Reference Voltages 314
Remote Annunciations 124
Remote Command 124
Remote Measured Values 353
Remote tripping 206
Reset 356
Resistance Tolerance 87
Retrieved Annunciations 349
To Next Page
Loading...
Need help?
General
