37SD610 Manual
C53000-G1176-C145-4
Preface
Purpose of this
Manual
This manual describes the functions, operation, installation, and commissioning of the
7SD610 devices. In particular, one will find:
• Information regarding the configuration of the device and descriptions of device
functions and settings → Chapter 2;
• Instruction for mounting and commissioning → Chapter 3,
• List of technical data → Chapter 4;
• As well as a compilation of the most significant data for experienced users → Ap-
pendix A.
General information about design, configuration, and operation of SIPROTEC 4
devices are laid down in the SIPROTEC 4 System Description /1/.
Target Audience Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking, and service of selective protective equipment, automatic and control
facilities, and personnel of electrical facilities and power plants.
Scope of validity of
the manual
This manual is valid for SIPROTEC Differential Protection 7SD610 Firmware-Version
V4.6
Indication of
Conformity
This product is UL-certified according to the Technical Data:
This product complies with the directive of the Council of the European Commu-
nities on the approximation of the laws of the Member States relating to electro-
magnetic compatibility (EMC Council Directive 89/336/EEC) and concerning elec-
trical equipment for use within specified voltage limits (Low-voltage directive 73/23
EEC).
This conformity is proved by tests conducted by Siemens AG in accordance with
Article 10 of the Council Directive in agreement with the generic standards
EN 61000-6-2 and EN 61000-6-4 for the EMC directive, and with the standard
EN 61000-6-2 and EN 61000-6-4 for the low-voltage directive.
This device was designed and produced for industrial use.
The product conforms with the international standard of the series IEC 60255 and
the German standard VDE 0435.
Further Standards IEEE Std C37.90-*
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General