ID/
Icons
Diagnostic Action Comment
197 CH2 Cable break. Check channel 2 current output
cable connection.
If Operation mode is config‐
ured to Current output
198 CH2 Frequency too low. Check process conditions
or align limit to normal operation. Adjust chan‐
nel 2 parameter 'Lower range value'
If Operation mode is config‐
ured to Frequency output
199 CH2 Frequency too high. Check process conditions
or align limit to normal operation. Adjust chan‐
nel 2 parameter 'Upper range value'
If Operation mode is config‐
ured to Frequency output
200 CH2 Pulse overflow. Pulse output insufficient pulse
separation. Reduce pulses per amount, or re‐
duce pulse width, or increase amount
If Operation mode is config‐
ured to Pulse output
201 CH3 Loop current in lower saturation. Check proc‐
ess conditions or align limit to normal operation.
Adjust channel 3 parameter 'Lower range value'
If Operation mode is config‐
ured to Current output
202 CH3 Loop current in upper saturation. Check proc‐
ess conditions or align limit to normal operation.
Adjust channel 3 parameter 'Upper range value'
If Operation mode is config‐
ured to Current output
203 CH3 Cable break. Check channel 3 current output
cable connection
If Operation mode is config‐
ured to Current output
204 CH3 Frequency too low. Check process conditions
or align limit to normal operation. Adjust chan‐
nel 3 parameter 'Lower range value'
If Operation mode is config‐
ured to Frequency output
205 CH3 Frequency too high. Check process conditions
or align limit to normal operation. Adjust chan‐
nel 3 parameter 'Upper range value'
If Operation mode is config‐
ured to Frequency output
Diagnostics and troubleshooting
9.8 Fault codes and corrective actions
SITRANS FST030 (Modbus)
Operating Instructions, 08/2018, A5E37367739-AD 113
To Next Page
Loading...
