Siemens SIWAREX FTC - Accessories

13 Accessories
There are necessary and optional accessories for the SIWAREX FTC.
The essential accessories are indicated in the following table.
Description Order-No.
SIWAREX FTC
Weighing electronics continuous weighing for S7-300 and ET200M.
EUtype approval (certificate) 3 x 6000d as non-automatic weighing instrument
Application areas: non-automatic weighing instrument, force measurement, belt
scales, loss-in-weight scales and flow meter.
7MH4900-3AA01
 SIWAREX FTC Device Manual
(The device manual is only available electronically and is available
through Internet page www.siemens.de/siwarex
)
SIWAREX FTC configuration package for SIMATIC S7 for belt scale on CD-
ROM
 SETUP for S7 integration as of Step7 V5.2
 S7- Function block, Getting started
 PC parameter software SIWATOOL FTC_B
 Manual on CD-ROM
7MH4900-3AK01
SIWAREX FTC configuration package for PCS7 V6.0 (only available for
belt scales) on CD-ROM

SETUP for S7- Integration
 Function block for the CFC-Plan
 Face plate for WINCC
 PC parameter software SIWATOOL FTC_B
 Manual on CD-ROM
7MH4900-3AK61
SIWATOOL-connection cable from SIWAREX FTC with a serial PC interface,
for 9 pin PC interfaces (RS 232)
 Length 2 m
7MH4702-8CA
 Length 5 m
7MH4702-8CB
 Front connector 40 pin,
with screw contacts (required for every SIWAREX assembly),
alternatively with spring-clamps - see next point
6ES7 392-1AM00-0AA00
 Front connector 40 pin,
with spring-clamps (required for every SIWAREX assembly), alternatively
with screw contacts - see next point
6ES7 392-1BM00-0AA00
 Shielding contact rail
sufficient for one SIWAREX FTC module group
6ES7 390-5AA00-0AA0
 Shielding connection clamp
Content: 2 pieces (suitable for cable of diameter 4 to 13 mm)
Note:
One shielding connection clamp is required for each of the following:
- Scale connection
- RS 485 interface
6ES7 390-5CA00-0AA0
13-124 SIWAREX FTC