HARDWARE CONFIGURATION AND ASSEMBLY
Whe
n connecting a single display, ensure that the RTa and RTb bridges are wired.
When installing the S102 for operation, the same parameters that have been set by
the SIWATOOL FTC for RS 485 are to be defined.
Figure 4-1
1 Connecting the S102 display
4.4.13 Connecting the PC for SIWATOOL FTC
Table
RS 232 Interface
Termination Clamp Signal Comment
X2 9 pin D-type RS 232 Interface
Table 4-10 Connecting the PC
Ready-made cables are available for connecting the PC (see
Accessories)
Figure 4-1
2 Connecting the PC
SIWAREX FTC
4-25
To Next Page
Loading...
