Siemens SIWAREX FTC - Table 7-1

WEIGHING FUNCTIONS AND PARAMETERS
Name Type Address Default Range of Values / Meaning Reference
Characteristic value
range
BYTE DBB036 2 1: Characteristic value to 1mV/V
2: Characteristic value to 2mV/V
4: Characteristic value to 4mV/V
101: Characteristic value +/- 1mV/V (force
measurement, bi-directional)
102: Characteristic value +/- 2mV/V (force
measurement, bi-directional)
104: Characteristic value +/- 4mV/V (force
measurement, bi-directional)
Other definitions not permitted.
5.2.2
(5) Filter
Filter sequence BYTE DBB037 0 Bit 0 :
0: Average value filter before digital filter
1: Digital filter before average value filter
Bits 1 to 7 not set
5.2.3
Type of low pass filters BYTE DBB038 0 0: critically damped
1: Bessel filter
2: Butterworth filter
Other definitions not permitted.
5.2.4
Limit Frequency BYTE DBB039 4 0: No filter
1: fg = 20Hz
2: fg = 10Hz
3: fg = 5Hz
4: fg = 2Hz
5: fg = 1Hz
6: fg = 0.5Hz
7: fg = 0.2Hz
8: fg = 0.1Hz
9: fg = 0.05Hz
Other definitions not permitted.
5.2.5
Depth of
average value filter
INT DBW040 10 [0 ... 250] x 10 ms
0: Average value filter deactivated
Other definitions not permitted.
5.2.6
(1) Adjustment parameter
I
0
Scale Name STRING
[10]
DBB042 „SIWAREX
XX“
5.2.7
Number of weight ranges BYTE DBB056 1 1 Range
2 Ranges
3 Ranges
Other definitions not permitted.
5.2.8
Scale type
Activate zero setting
upon start-up
Activated zero setting at
start-up, if scale is tared
Automatic zero
adjustment
BYTE DBB057 0
0
0
0
Bit 0::
0: Multi-range scale
1: Multi-resolution scale
Bit 1:
0: Switch-on zero setting device switched off;
1: Switch-on zero setting device switched on
Bit 2:
0: Switch-on zero setting, not when tare  0
1: Switch-on zero setting performed with tare  0
Bit 3:
0: Zero tracking device switched off;
1: Zero tracking device switched on
Bit 4 - 7 not set
5.2.9
5.2.10
5.2.11
5.2.12
(2) Calibration parameter
II
Minimum weight for
Weighing range 1
REAL DBD058 1
5.2.13
SIWAREX FTC
5-33