Siemens Synco 700 - Raising the Economy Setpoint; Room Temperature Setpoint Adjuster, Absolute

121/238
Building Technologies Modular Heating Controller RMH760B CE1P3133en
HVAC Products 9 Heating circuit control 05.02.2007
The effective setpoint appears on the Main menu and on the info page.
Main menu > Heating circuit 1 (or 2 or 3) > Inputs/setpoints
Operating line
Adjustable values / display / remarks
Current room temp setpoint
…°C
Room setpoint absolute*
…°C
Room setpoint relative*
…°C
* Only if configured via “Extra configuration“
9.4.2 Raising the Economy setpoint
The room temperature setpoint in Economy mode is increased as a function of the
composite outside temperature. The increase is greater at low outside temperatures
and reduced to zero at high outside temperatures, whereby starting and end point are
adjustable.
The function helps prevent peak loads when changing from Economy to Precomfort or
Comfort mode.
3133D04
TOeff
TRSetpt
TRSetptEco
TRSetptPreC
TRSetptCmf
–15°C
EndPt
–5°C
SrtPt
TRSetptEco+
Δ
TRSetptEco+
Δ /
TRSetptPreC+
Δ
EndPt
End point of increase (–15 °C in the graph)
SrtPt
Starting point of increase (–5 °C in the graph)
TOeff
Composite (effectively acting) outside temperature
TRSetpt Room temperature setpoint
TRSetptCmf Comfort setpoint
TRSetptEco
Economy setpoint
TRSetptEco+
Δ
Increased Economy setpoint
TRSetptPreC
Precomfort setpoint
TRSetptPreC+
Δ
Increased Precomfort setpoint
Main menu > Settings > Heating circuit 1
(or 2 or 3) > Optimizations/influences
Operating line Range Factory setting
Economy increase starting point
–15…50 °C –5 °C
Economy increase end point
–50…–5 °C –15 °C
The
Inputs/setpoints menu shows the state of the increase:
Main menu > Heating circuit 1 (or 2 or 3) > Inputs/setpoints
Operating line
Adjustable values / display / remarks
Economy increase Inactive / Active
9.4.3 Room temperature setpoint adjuster, absolute
For the preselected room temperature setpoints Comfort and Precomfort, a remote
setpoint adjuster (e.g. BSG21.1) can be configured.
The 4 setpoints will be readjusted according to the following diagram.
Display of inputs and
setpoints
Settings
Display values