TXP-CLC Course
6
Assigning Hardware module
and channel:
YDH
YDM
YDR
Properties
Module parameter
Cut
Deselect
Copy
Move
Connect
Open connection
Go down
CPU References
System
Module parameter
Properties
Module parameter
Cut
Deselect
Copy
Move
Connect
Open connection
Go down
CPU References
System
Go down
Properties
Module parameter
Cut
Deselect
Copy
Move
Connect
Open connection
Go down
CPU References
System
Go down
Diagram
-
+
G
X
Create
Open
Save
Close
Save&Close
Reload
Print ...
open signals
YFH
YFM
YFR
YDH
YDM
YDR
YOP
*
Paste
Refresh
Connect
go up
Paste
Refresh
Connect
go up
Open the YDR diagram for your
ET200 station
Left click on the module that
needs to be configured
Using the middle mouse button
open the “module parameter”
mask
Fill in “id code” and “sig” fields
(destination field is only used for
outputs and special DCM inputs)
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
2
To Next Page
Loading...
