Siemens TXP-CLC - Ulll1; Ulll2; Ulll3; Ulll4

TXP-CLC Course
8
ULLL1
This parameter defines the triggering direction of limit value 1. There are 2
possible choices in the parameter mask: 0 and 1 where 0 = lower limit trigger and
1 = upper limit trigger.
ULLL2
This parameter defines the triggering direction of limit value 2. There are 2
possible choices in the parameter mask: 0 and 1 where 0 = lower limit trigger and
1 = upper limit trigger.
ULLL3
This parameter defines the triggering direction of limit value 3. There are 2
possible choices in the parameter mask: 0 and 1 where 0 = lower limit trigger and
1 = upper limit trigger.
ULLL4
This parameter defines the triggering direction of limit value 4. There are 2
possible choices in the parameter mask: 0 and 1 where 0 = lower limit trigger and
1 = upper limit trigger.
EGSW1
This parameter defines the substitution value of limit signal 1 (GS1) that will be
processed further in the event of a channel fault (only applicable when parameter
EGS1 is set to ”1”). There are 2 possible choices in the parameter mask: 0 and 1.
Meaning:
0 = substitution limit signal = 0
1 = substitution limit signal = 1
The default setting is 0
EGSW2
This parameter defines the substitution value of limit signal 2 (GS2) that will be
processed further in the event of a channel fault (only applicable when parameter
EGS2 is set to ”1”). There are 2 possible choices in the parameter mask: 0 and 1.
Meaning:
0 = substitution limit signal = 0
1 = substitution limit signal = 1
The default setting is 0
EGSW3
This parameter defines the substitution value of limit signal 3 (GS3) that will be
processed further in the event of a channel fault (only applicable when parameter
EGS3 is set to ”1”). There are 2 possible choices in the parameter mask: 0 and 1.
Meaning:
0 = substitution limit signal = 0
1 = substitution limit signal = 1 The default setting is 0
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
9