TXP CLC Course
11
Connections to SIM Modules for Drive Control
To perform the drive control functions, one DCM function block is invoked in the
AP for each motor or solenoid valve. There are two possibilities of input and
output allocation:
1. Direct allocation of the block inputs and outputs to SIM I/O modules. This is
made via the rack level parameter masks.
2. Decoupling. The inputs are acquired via binary input blocks and can be
connected to the FB163 function block after processing. In the same way, the
command output can be done via binary output blocks.
Mixed application of decoupling and direct allocation is possible.
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
7
To Next Page
Loading...
