TXP CLC Course
The signals RME, RMA, and SAG can be configured as either a NO or NC
contact
If the following signals are not wired, the function block reads them as follows:
• SAG = “0” (not faulty) Parameter “RMS” set for NO contact.
• ANB = “0” (ready or racked in)
• RME = not RMA
• RMA = not RME
When Feed-backs are not wired the command outputs are used for the
generation of the feed-back messages as follows:
• RME = ALE
• RMA = ALA
Depending on the operating voltages used, the following SIM modules can be
used in conjunction with the DCM function block:
SIM inputs:
• 321-1BL00-0AA0 32 x DC 24V Motor/Solenoid valve inputs
• 321-1BH01-0AA0 16 x DC 24V Motor/Solenoid valve inputs
• 321-1EH01-0AA0 16 x AC 120V Motor/Solenoid valve inputs
• 321-7BH00-0AB0 16 x DC 24V with sensor supply and diagnostics for
Motor/Solenoid valve inputs
SIM outputs:
• 322-1BL00-0AA0 32 x DC 24V / 0.5A Motor/Solenoid valve outputs
• 322-1BH01-0AA0 16 x DC 24V / 0.5A Motor/Solenoid valve outputs
• 322-1HH00-0AA0 16 x REL AC 120V / 0.5A Motor/Solenoid valve outputs
• 322-1HF01-0AA0 8 x REL AC 230V / 0.5A Motor/Solenoid valve outputs
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
2
To Next Page
Loading...
