TXP CLC Course
7
3.Now you are in the process of creating a connection. Move the mouse rightwards
without pressing any buttons, until the cursor is in the output area of the function plan.
As shown in 3.
Then press the left mouse button and hold down the middle mouse button to select
“positive signal” from the menu bar
4. Now assign the SIGDEF in the pop up window as shown in 4. Some module ports give default
“signal” (e.g. CB ON is always XB01), but this can be changed.
Select “SIGDEF” from the drop down list, and click OK. Do not enter or select any information
in the “dest.” Field.
5. In the next mask you can give more detail about the signal. The “designation” , “setting”, and
unit fields are used to
ive short ex
l
nation of this si
nal’s function within this dia
ram.
Training Center
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
5
To Next Page
Loading...
